DSG Re-calibration and Throttle Body Re-alignment

VW EOSからAudi A3 Sedan (8V) への今年中の乗換えは既に決定していますが、6月に車検を更新した後に、9月からやっとデリバリーされる「S line」まで待ちます？！

そこで、DSGの調子を整えるために、週末に「DSG Re-calibration and Throttle Body Re-alignment」を実施しました。

使用したツールは「VCDS 12.12」で、以下の手順で行いました。

1) Transmission Tolerances (Engaged Calibration)
Group 061
[Go!]
When you go to Basic Settings 061 and click GO the screen may look like this: Basic Settings 061
Wait until the numbers quit moving and the trans will quit making noises. Basic Settings switches to On when finished: Basic Settings 061
Wait until Basic Settings has switched to ON and all numbers have stopped moving. This may take one minute.
　
2) Transmission Tolerances (Synch. Point. Measurement)
Group 060
[Go!]
When you go to Basic Settings 060 and click GO the screen may look like this: Basic Settings 060
Wait until the numbers quit moving and the trans will quit making noises. Basic Settings switches to On when finished: Basic Settings 060
Wait until Basic Settings has switched to ON and all numbers have stopped moving.
　
3) Special Procedures
Defined Test Drive
Suggested test drive after replacing the mechatronic or successful basic setting.

Prerequisites:
Fluid Temperature 30...100 °C (86...210 °F), see Measuring Blocks, Group 019.
Do Not use Cruise Control.
Drive in Tiptronic Mode from stand still up to 6th Gear.
While doing that make sure to drive in Gears 3 or 5 for approx. 5 minutes and also in 4 or 6 for approx. 5 minutes.
The engine speed window for all gears is 1200 - 3500 RPM (for clutch calibration).
Perform one sharp braking followed by a full throttle acceleration (oil return check) while in Drive, Not Tiptronic Mode.
Evaluate creep and starting-off points.
Check for leaks.
NOTE: If the test drive cannot be performed in the recommended way or the necessary time, any remaining adaptations will be performed automatically during normal driving.

結果は、新車時を思い出すような、DSGのフィールに戻った感じです！！！